Kärcher K 2.360, Руководство по эксплуатации

Страница: 6 / 20

6 English
Illustrations on Page 2
1 High pressure connection
2 Appliance switch "0/OFF“/ „I/ON“
3 Storage for high pressure hose
4 Transport handle
5 Storage for spray lance
6 Garden hose connector (female)
7 Coupling element for water connection
8 Connection for water supply with filter
9 Suction hose for detergent
10 Detergent Tank
11 Storage for trigger gun
12 Mains cable with mains plug
13 Bearing wheel
14 Trigger gun
15 Lock trigger gun
16 Clamp for high pressure hose
17 High pressure hose
18 Washing brush
19 Spray lance with Dirtblaster
20 Spray lance with pressure regulation
(Vario Power)
Special accessories expand the possibilities
of using your appliance. Please contact your
KÄRCHER dealer for further information.
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 2
Illustration
 Insert the transport handle.
Illustration
 Insert the transport wheels and lock them.
Illustration
 Pull out the clamp for the high-pressure
hose from the trigger gun (e.g. with a
small screwdriver).
Illustration
 Connect high pressure hose to trigger
gun.

Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
CAUTION
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Illustration
1 Screw the coupling element to the wa-
ter connection on the appliance.
2 Screw the supplied garden hose con-
nector on to the end of your garden
hose.
3 Push the garden hose connector on to
the water inlet connector and make
sure you hear it click into place before
proceeding.
 Connect garden hose to the cold water
source and turn water on completely.
CAUTION
Dry runs lasting longer than two minutes
lead to damages to the high pressure
pump. If the appliance does not build up
pressure within two minutes, switch it off
and proceed as instructed in the Chapter
"Troubleshooting".
Operation
Description of the Appliance
Special accessories
Before Startup
Water supply
Water supply from mains
Start up