11
TROUBLE SHOOTING
- continued
If you encounter any additional
difficulties not listed, please call
our service center for help.
Symptom Cause
Solution
No detergent.
Garden hose
connection leaks.
Spray wand leaks.
Pump is noisy.
Water leaks from
pump (up to 10 drops
per minute
is permissible).
Oil Drip.
Detergent is too thick.
Dilute detergent, for best results
use Kärcher detergent.
Filter on detergent suction
tube is clogged.
Run warm water through filter to
remove debris.
Damaged or clogged
detergent suction tube.
Remove obstruction or replace
detergent suction tube.
Spray wand is in high
pressure position.
Turn spray wand tip to low pressure
position.
Discharge nozzle is
obstructed.
Blow out or remove debris with a
fine needle.
Loose fitting.
Tighten fittings.
Missing/worn rubber washer.
Insert new washer.
Spray wand not properly
attached.
Broken o-ring or plastic
insert.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until
a steady flow of water emerges
through the nozzle.
Loose fittings.
Check that all fittings are tight.
Call service center.
Water seals are damaged
or worn.
Thermal protection device will
automatically reset.
Thermal protection device
has been activated.
Call Kärcher customer service
hotline and order repair kit
(part no. 2.883-111.0).
Pump is sucking air.
Oil seals are damaged or
worn.
Call service center.
Insert the spray wand into the trigger
gun. Carefully press in against the
spring tension and twist into the
locked position.
Detergent suction tube not
properly connected to the
machine.
Check connection.
In USA Call:
1-800-537-4129
or visit our website: www.karcher-usa.com
