13
Operations
Handle Installation
The handle must be installed by qualified personnel. Read all instructions thoroughly. The machine is
shipped with handle unassembled.
La poignée doit être installée par du personnel qualifié. Lisez toutes les instructions attentivement. La
machine est livrée avec la poignée démontée.
The machine is shipped with handle unassembled.
Follow these steps for installation:
1.
Remove handle and chassis assembly from carton.
2.
Attach handle assembly to base using hardware kit (attached to handle in a plastic bag) items 1 and 2.
NOTE: The bushings (items 1) are required for the correct operation of the handle. The bushings are
positioned inside the pivot holes in the chassis, and are held in place by tightening the screws (item 2) against
the bushing.
3.
Remove bolt, nut and washers (items 3, 4 and 5) from lower block on handle assembly. Attach links as
shown. Tighten bolt and nut securely, then back off 1/4 to 1/2 turn.
4.
Check handle for movement up and down.
5.
Plug motor cord into handle cord receptacle.
(SEE NOTE)
HOLE
PIVOT
ASSEMBLY
CHASSIS
PLUG
MOTOR
RECEPTACLE
MOTOR PLUG
4
5
1
2
3
THE CORD ASM AND CORD HOOK.
ASSEMBLY, CHECK ORIENTATION OF
WHEN INSTALLING THE HANDLE
86386990 Operators Manual - Floor Polisher
