Kärcher BD 43/35 C Ep, Инструкция по эксплуатации

Страница: 11 / 184

-
3
1 OFF
Device is switched off
2 Normal mode
Wet clean the floor and vacuum up dirt
water.
3 Intense mode
Wet clean the floor and allow the deter-
gent to react.
4 Vacuum mode
Suck in the dirt fleet.
5 Program selection switch
6 Indicator light voltage supply
Glows when the mains plug is inserted
and when there is mains voltage.
** option
 Employ 2 persons to lift the device off
the pallet and set it on the floor.
 Insert the vacuum bar into the vacuum
bar suspension in such a manner that
the profiled sheet is positioned above
the suspension.
 Tighten the wing nuts.
 Insert the suction hose.

DANGER
Risk of injury!
In dangerous situations, release the safety
switch/drive lever.
 Open the lock of the fresh water reser-
voir.
 Fill fresh water (maximum 60 °C) until
the lower edge of the filling nozzle.
 Close the lock of the fresh water reser-
voir.
몇 WARNING
Risk of damage. Only use the recommend-
ed detergents. With other detergents, the
operator bears the increased risk regarding
the operational safety and danger of acci-
dent.
Only use detergents that are free from sol-
vents, hydrochloric acid and hydrofluoric
acid.
Follow the safety instructions for using de-
tergents.
Note:
Do not use highly foaming detergents.
Recommended detergents:
 Add the detergent to the fresh water
reservoir.
Note:
If the fresh water tank is empty, the clean-
ing head continues working without liquid
supply.
 Adjust the water quantity using the reg-
ulating button according to the dirt on
the floor covering.
Note:
Carry out initial cleaning attempts with low
water volume. Increase water volume step-
by-step until the desired cleaning result is
achieved.
To improve the vacuuming result on tiled
floors the vacuum bar can be turned to an
oblique position of up to 5°.
 Loosen the wing nuts.
 Turn the vacuum bar.
 Tighten the wing screws.
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.
 Adjust the rotary handle to incline the
suction bar.
The bend of the suction lips upon contact
with the floor is influenced with the height
adjustment.
 Try adjusting the twist handles of the
height adjustment until the best vacu-
uming result is achieved.
Operator console
Symbols on the machine
Mains plug
Lashing point
Mop holder **
Filling level fresh water
tank 25%
Bow brush change
Vacuum bar lowering le-
ver
Drain outlet fresh water
tank
Dirt water discharge
hose
Before Startup
Unloading
Installing the Vacuum Bar
Operation
Filling in detergents
Fresh water
Detergent
Application Detergent
Routine cleaning of all water
resistant floors RM 746
RM 780
Routine cleaning of glossy
surfaces (e.g. granite) RM 755 es
Routine cleaning and basic
cleaning of industrial floors RM 69 ASF
Routine cleaning and basic
cleaning of fine stoneware
tiles RM 753
Routine cleaning of tiles in
sanitary areas RM 751
Cleaning and disinfection in
sanitary areas RM 732
Removal of coating from all
alkali-resistant floors (e.g.
PVC) RM 752
Removal of coating from li-
noleum floors RM 754
Setting the water quantity
Setting the Vacuum Bar
Oblique position
Inclination
Height
11 EN