9.800-414.0 • Rev. 11/09
PRESS
u
RE WASHER Troubleshooting Guide
26
TrOUbLESHOOTiNg
prObLEM
pOSSibLE cAUSE
SOLUTiON
ENgiNE OpErATES
fOr 15 MiN. THEN
STOpS
Not enough gas or engine oil
Fill tank with gas. Check oil level.
Vapor lock developed by heat of
day
Keep gas tank full to avoid vapor locking.
Obstruction in fuel filter
Clean or replace fuel filter.
ENgiNE LAckS
pOwEr
Dirty air filter
Replace air filter.
ENgiNE fALTErS
Choke is opened too soon
Move choke to halfway position until engine
runs smoothly.
wATEr DrippiNg
frOM
UNDEr pUMp
Piston packing worn
Contact local dealer or technical support.
O-Ring plunger retainer worn
Contact local dealer or technical support.
Cracked piston
Contact local dealer or technical support.
OiL DrippiNg
Oil seal worn or damaged
Contact local deale or technical support r.
wATEr LEAkiNg
frOM pUMp prOTEc-
TOr
Spray gun closed with machine
running 5 minutes or longer
Open spray gun or turn off machine.
Excess water supply pressure
Place a pressure regulator at end of 50'
garden hose.
NO DETErgENT
Detergent suction tube not prop-
erly connected to machine
Check connection.
Detergent is too thick
Dilute detergent. For best results, use our
detergent.
Detergent filter valve is at lowest
setting
Set detergent filter valve to a higher setting.
Filter on detergent suction tube is
clogged
Run warm water through filter to remove
debris.
Damaged or clogged detergent
suction tube
Remove obstruction or replace detergent
suction tube.
a high pressure nozzle is at-
tached.
Replace with black detergent nozzle.
Discharge nozzle is obstructed
Blow out or remove debris with fine needle.
gArDEN HOSE
cONNEcTiON LEAkS
Loose fittings
Tighten fittings.
Missing/worn rubber washer
Insert new washer.
SprAY wAND LEAkS
Spray wand not properly attached Slide the spray wand into the gun. Turn the
wand collar clockwise onto the spray gun
threads until tight.
Broken o-ring
Contact local dealer to order an o-ring.
pUMp iS NOiSY
Pump is sucking air
Check that hoses and fittings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady flow of
water emerges through nozzle.
Содержание BD-405039E
Страница 2: ......
Страница 27: ......
Страница 28: ...Form 9 800 414 0 Revised 11 09 Printed in U S A or Mexico...