Kärcher 2.111-012.0, Оригинальное руководство пользователя

Страница: 8 / 88

– 3
Figure 6, see cover page
 Unscrew the covering nut.
 Remove joint.
Figure 7, see cover page
 Attach hand spray gun.
 Tighten the union nut.
Figure 8, see cover page
몇 CAUTION
A strong wastewater jet will emerge from
the hose connection. Do not use the sur-
face cleaner without a hose.
 Insert the hose into the hose connection
and secure by rotating.
 Route the other end of the hose to a
drain.
 Hold the appliance at the handle while
cleaning the wall.
 Guide the surface cleaner so that it re-
mains close to the surface to be
cleaned.
 After operation with hot water, operate
the surface cleaner with cold water for
two minutes to cool it down.
 If necessary, rinse the surface cleaner
and the suction hose with clear water.
 Protect the appliance against frost.
 Do not allow bristles to deform during
storage.
Note: In order to ensure a good suction re-
sult, please do not place the surface clean-
er FRV 30 onto the bristle crown after use.
To protect the brush bar from damages,
you can also remove it while storing the
FRV 30.
 Rinse the steering rollers with clear wa-
ter after use and spray with creeping oil
after they have dried.
Rotation arm does not rotate:
 Check if the cleaning nozzles are dirty.
Vacuum performance decreasing:
 Bristle crown worn - replace bristle
crown.
 Suction channel/suction hose blocked -
clean suction channel and suction
hose.
 Injector nozzle blocked - clean the in-
jector nozzle.
Only use original accessories and spare
parts, they ensure the safe and trouble-free
operation of the device.
For information about accessories and
spare parts, please visit www.kaerch-
er.com.
Wall cleaning
Shutting down
Care
Accessories
Accessories Order number
Hose fastener (suction
cup to install on smooth
surfaces) 2.642-528.0
Dirt catcher (coarse dirt
separator) 2.642-532.0
Hose support (wall
mount) 2.042-001.0
Brush crown 6.371-293.0
Extension hose 4.441-040.0
Troubleshooting
Spare parts
8 EN