- 7 -
SQLFW Powered Sub-woofer series
the frame must be stripped of all paint to make a proper electrical
connection. The distance to the ground should be as short as possible
and no more than 18”.
do not
connect
the
powered
sub
-
woofer
to
the
vehIcle
’
s
battery
ground
termInal
.
4.
Bassboost
The
Bassboost
can boost the bass frequency level by 0dB to 12dB.
The boost frequency is centred at 50Hz.
5.
LPF
(Low Pass Filter) Control
The
LPF
controls the low pass crossover to select the desired
frequency. The frequency can be adjusted from 40Hz to 220Hz.
6.
GAIN
Control
Use the
GAIN
Control to fine-tune the input sensitivity of the
amplifier to the source unit’s output level. The operating range is
from MIN to MAX. This is NOT a volume control!
7.
Wired Bass Remote Jack
Provides a wired remote control to the drivers seated location. The
Bass Remote
controls the amplifier’s volume adjustment.
8.
RCA
Input
Jacks
RCA Input
jacks are for use with source units having RCA or low level
output. Source units with an output signal level of minimum 200mV
may be used. (See installation wiring diagram)
9.
Power
Indicator
The LED indicates the amplifier is functioning properly when the LED
is lit.
10.
Protection
Indicator
The LED will light up red and will flash if there is a fault detected
by the amplifier. Disconnect the sub-woofer. Check and fix the
connections to resolve the fault condition.
11.
High Level Input
Amplifier can use high level input from the source units existing
speakers or output if low level RCA jacks are not available on the
source unit. (See installation wiring diagram). The SQLFW110PS
power amplifier is equipped with current sensing so it will detect a
signal from the vehicles source unit. Therefore the remote lead does
not have to be wired to remote lead input on the amplifier.
