Step 17
Slide the remaining 2 back panels
into the back panel grooves on both
ends on the unit.
Step 18
Insert wood dowels into the middle
pre-drilled holes on the ends of each
of the shelves. 4 on the right side,
and 4 on the left side.
*You may need a hammer to tap dowel
into place if dowel is to tight.
Step 19
With the end of the unit hanging off
the edge of the table, place the end
panel against the side of the unit, and
line up the dowels, with the corresponding
dowel holes on the end panel.
Step 20
When the end panel is flush against
the edges of the shelves, you can secure
the end panel in place with 8 hex head
screws. Using the allen wrench, tighten
screws clockwise until snug.
Repeat steps 19 and 20 for opposite side.
