Preparing the Shelf
24.
Attach the rear fence to the shelf
using M5 nuts and bolts.
25.
Tighten to secure.
24
25
8
9
22
20
19
18
Molle Panel Installation
Follow the instructions to suit your
configuration below.
To install the Large Side Molle Panel:
17.
You will have already installed
the Large Side Molle Panel and
Standalone Shelf handle bracket as
per the instructions provided.
Skip to step 24.
To install the Small Side Molle Panel:
18.
Ensure you have the correct panel
and Standalone Shelf handle
bracket for each side. The nutsert
on the handle bracket should point
towards the front of the vehicle, and
the Molle panel should be oriented
as pictured.
19.
Place the M10 bolt, washer and
25mm spacer on the the bottom
mounting point of the Small Molle
Panel, as shown.
20.
Thread the bolt/spacer through the
hole we drilled in the trim before
loosely tightening into the captive
nut behind.
21.
Sandwich the Shelf Handle Bracket
over the top of the Small Molle
Panel as shown. Carefully align the
M6 bolts with the holes in the roof,
making sure not to push the captive
nuts out of the retainers.
22.
Make any necessary adjustments
to the Small Molle Panel and
Handle brackets before tightening
all bolts.
23.
Repeat on the other side.
