WARNING
Never over-tighten a bolt into the back of your
fl
at panel TV.
Do not lay the TV face down on its glass front. Use a TV stand or lean against a wall.
Step 1: Attach TV Brackets (extend if necessary)
Step 1.1
Select the correct size of bolt
Kanto provides 3 bolt diameters (Metric sizes M5, M6
and M8) in various lengths.
Part items:
A
,
B
,
C
,
D
,
E
,
F
or
G
.
Select the correct bolt diameter and hand tighten into
the back of the TV to determine the correct length.
Use the washer (
H
) for bolts
A
-
D
(sizes M5 and M6).
The washer will work for all bolt sizes. The washer is
not required for M8 size bolts (
E
,
F
&
G
). If your TV has
a curved back or the mounting holes are recessed, you
can use the spacers (
J, K
).
Step 1.2
Attach TV bracket arms to the back of the TV
Now that you have selected the correct bolt length and
spacers if necessary, it’s time to attach the arms (
P
) to
the TV, as shown in Diagram A.
Diagram A
Washer (H) used
with bolts A thru D
Bolts (A thru G)
There are a wide variety of TVs available requiring an assortment of bolt sizes. We provide a selection of mounting
bolts to
fi
t most TVs. If you have any concerns about this mounting hardware or installation call us direct at 1-888-
848-2643 or email at [email protected]
The T6090 uses 400mm brackets for most TVs, but is shipped with extensions that you should connect if your
TV has vertical VESA spacing up to 600mm, or if you require vertical shift. All extension parts are supplied in a
separate package with washers and nuts attached. Remove nuts and washers, and see the inset below to attach the
extensions.
Quick-Lock TV brackets (P)
Spacer (J, K), depending on
length of bolt and depth of
recess
VESA Extension Arms
4
