Supporting your digital lifestyle
™
Supporting your digital lifestyle
™
5
CAUTION
Make sure the supporting surface will support
the load limits outlined in the Caution at bottom of page
two. Tighten Lag Bolts until the Wall Plate is snug flat
against the wall. Do not over tighten Lag Bolts (K). Each
Lag Bolt must be located in the center of a wood stud.
CAUTION
Make sure the concrete or brick wall is at least
3.5” thick. Make sure the anchor is seated completely
flush with the concrete surface even if there is another
layer of material, such as drywall. If drywall is over 5/8”
thick custom lag bolts must be used. Concrete must be
a minimum of 2000psi in density.
Diagram B
Diagram C
Wood
Concrete
3/16”
(5 mm)
3” (75 mm)
3” (75 mm)
7/16”
(11mm)
I
K
I
K
L
Step 2: Mount Wall Plate
Wood Stud Wall
The Wall Plate can be mounted to three wood studs with
16” centers, or to two wood studs with 24” centers. Use
a stud sensor to locate the studs, clearly marking the
outer edges of the studs. Use a long level to ensure the
holes are level at the desired height.
Pre-drill the upper holes in the center of your studs,
and attach the Wall Plate to the wall using Lag Bolts
(K)
and Lag Bolt Washers
(I)
(see Diagram B for three stud
installation - we recommend you center the plate if you
have two 24” studs). Do not over-tighten lag bolts
(K)
.
Make sure the Wall Plate is flat against the wall surface.
Using the Wall Plate as template, pre-drill the bottom
holes, and secure using Lag Bolts
(K)
and Lag Bolt
Washers
(I)
, taking care not to over-tighten.
Brick or Concrete Wall
Using the Wall Plate as a template, mark six holes (four
toward the outer edge of the Wall Plate and two near
the center) at your desired height (see Diagram C).
Adjust the Wall Plate position to be clear of mortar
joints, keeping in mind that the mount provides minor
horizontal shift along the length of the Wall Plate. Use
a long level to ensure the six holes are level and at the
desired height.
Pre-drill six holes perpendicular to the wall, and insert
a Concrete Anchor
(L)
into each of the holes flush with
the concrete wall surface and not flush with the surface
covering, such as drywall.
Attach the Wall Plate using 6 Lag Bolts
(K)
and Lag Bolt
Washers
(I)
(see Diagram C). Make sure the Wall Plate
is flat against the wall surface. Do not over-tighten
Attach the two plastic End Caps (
M
) to the Wall Plate.
