①
②
③
・
・
・
・
・
・
・
・
・
・
・
・
・
：
①
②
③
①
②
③
※
④
⑤
※
⑧
Places with a lot of dust, dust, etc.
Places where acid gas, corrosive gas, etc. are floating
Places with low atmospheric pressure
Places with conductive suspended matter (carbon fiber, etc.)
atten:
When carrying, do not hang a hoist or hanging band on the handle.
In a closed room and in a case
A place where the back is close to a wall
Places above 1000m above sea level
Places with an ambient humidity over 85% R.H.
Places other than ambient temp 0 to + 40 ° C
Near combustibles
Places that cannot be installed or used
Place with vibration
Places exposed to wind and rain outdoors
Top of fever
１．Installation
Install it in a horizontal position.
Please fix it firmly if necessary.
２．Piping
fix the piping to the outlet
Due to the characteristics of the flexible hose, hot air leaks from the flexible hose piping to the outlet. The leaked hot air will flow
back into the multi-dryer and cause damage to the electronic devices in the operation panel. Use the enclosed glass tape to prevent
air leakage and install the flexible hose piping to the outlet
３．Power supply
Make the piping as thick and short as possible, and install it with a gentle bend.
Be sure to insulate the piping sufficiently.
Please provide a dedicated circuit. When installing an earth leakage breaker, make a decision with a
sensitivity current of about 50mA as a guide.
The sensitivity current of the earth leakage breaker is generally about 10 times the initial leakage current.
To prevent electric shock accidents, perform grounding work (class D grounding).
Ask an electrician for power connection and grounding work.
Do not use the 100V type with the same outlet power supply at the same time as other devices.
For 200V type, use the attached outlet for wiring.
Connect the 200V type power cord according to R (red), S (black), and ground (green + yellow: with ground seal).
Be sure to use a commercial power supply (50 / 60Hz) with a sinusoidal waveform for the multi-dryer.
Never use a power supply that has distorted waves containing harmonics. Also, take sufficient measures to
prevent surge voltage and noise from entering the power supply.
Atten:
Please note that wiring that is too long will cause a voltage drop.
Atten:
Be sure to shut off the power supply during wiring and inspection. Even if the power switch of the main unit is turned off,
the operation circuit of the multi-dryer is still energized, so be sure to turn off the factory power supply (primary power
supply). If you work with the power turned on, you will get an electric shock.
Atten:
If you provide an outlet for the connection, ensure sufficient capacity. Please refrain from using the outlet as much as
possible because the outlet may generate heat or break down due to poor contact due to deterioration over time, phase
loss, etc.
Atten:
A multi-dryer is a device mainly used in an industrial environment. When used in a residential environment, etc., there is a
risk of radio interference. At that time, the user of this product may have to take appropriate measures to reduce the
obstacle.
※When using a single-phase 100V power supply with a single-phase three-wire low-voltage distribution system,
the single-phase 200V power supply can be easily taken out from the distribution board. If you are using a single-phase 200V model,
please consult with an electrician, including the power supply capacity.
－１－
