【
2
】
ADJUSTING THE TOP FEED DOG FRONT TO BACK
When top feed dog
①
is at the extreme rear end of
its travel with a maximum front-to-back movement
amount of 7mm (=L), there should be a clearance of
1mm between top feed dog
①
and the end of each
slot on the presser foot. Adjustment is made by
tightening set screw
③
on front-to-back lever
②
.
【
3
】
ADJUST THE TOP FEED DOG STROKE
To obtain a stroke of 4.7mm, remove the cover, loosen nut
①
, move rod pin
②
up or down
and then align the center of rod pin
②
with alignment mark
③
on the center of the
up-and-down shaft driven lever. To decrease the stroke, move up rod pin
②
(min.:3.5mm). To increase the stroke, move down rod pin
②
(max.:6.0mm).
3
