1
【
1
】
HOW TO USE THE THREAD TRIMMER
■
Pressing the pedal with toe (position A) starts the
machine.
Releasing the pedal (position B) stops the needle at the
top/bottom of its stroke (adjustable with the motor).
■
If the needle stops at the bottom of its stroke as adjusted,
pressing the pedal with heel (position C) raises the needle.
As soon as the needle stops at the top of its stroke by
pressing the pedal with heel, the thread trimmer gets
actuated (if the needle stops at the top of its stroke as
adjusted, the thread trimmer gets actuated by pressing
the pedal with heel).
■
Returning the pedal to position B lowers the presser foot.
■
The presser foot can be raised or lowered freely by releasing the pedal (position B) or
pressing the pedal with heel (position C) until the pedal is placed at position A for the
next sewing operation after the threads are cut.
【
2
】
INSTALLING THE POSITION DETECTOR
■
Install position detector A and tighten screw B
temporarily.
■
Fit positioner bar C onto the guide groove of the position
detector. Then tighten screw D.
■
Turn on the motor.
■
Press the pedal with heel after two to three stitches are
formed by pressing the pedal with toe.
Then the needle stops.
■
Loosen screws B for the position detector.
Turn the machine pulley while checking that the position
of screws B is not shifted.
Align mark P on handwheel E with the alignment mark
on the arm. Then the needle bar is at the top of its
stroke.
Tighten screws B to secure the position detector.
■
Check to see if the needle bar stops at the top of its stroke
by pressing and then releasing the pedal.
< Note >
Do not use this thread trimmer with no fabric under the presser foot.
< Note >
Remove the connector for the thread trimmer cylinder.
Make sure the knife is retracted all the way.
