11
10
INSTRUCTIONS FOR USE
3. Primers for pumps: fill the suction tube and pump chamber with water.
1. Check the power supply, make sure the voltage: 220VAC.
3. Check the stability of the output water flow.
•
The pump must be grounded.
•
Do not move the pump while it is operating.
4. Check the impeller: Use the screwdriver to rotate the motor shaft at the rear of the
pump.
4. Check the tightness of pushing and thrusting tube.
•
Use the pump at home
1. Supply power to the pump
•
Only use pumps for water, not for corrosive liquids and chemicals.
•
Avoid direct contact with the pump motor.
2. Ensure the tightness of pushing and thrusting tube.
II. Operation
•
Put the pump in a dry place.
III. NOTE:
2. Check the noise of the pump
I. Before use:
•
Make sure the luppe is always below the water level of the water supply.
MAINTENANCE AND SERVICE
Pump maintenance needs to be done every 06 months by following these steps:
• Clean the installation location of the pump, ensuring that when the pump is operating,
it will not suck objects such as: nylon, dirt, ... causing jam, fire of the pump.
• If not in use for a long time, need to remove the pump, clean and store the pump in a dry
place. Seal the pump's suction and ejector to avoid strange objects from clogging or
giving off odors.
• Clean the luppe, impeller, pump body, etc.
• Check the tightness of pushing and thrusting tube.
• Check the power supply for the pump, make sure the power cord does not leak, do not
scratch.
