Kangaroo Hillcrest ABX, Руководство пользователя

Страница: 13 / 74

Assembl
y
12
Assembling your X-Series Motorcaddie
Your Kangaroo X-Series Motorcaddie is shipped without the rear wheels attached. See pages 37 and 38 for rear
wheel assembly and removal instructions.
1. Steady the Chassis by using the hand-hold, located in the bottom of the battery tray. Insert the Electronic
Front Drive into the hole located in front of the battery tray, and close the draw latch. (Figure 1)
Note: The Upper Caddie Structure and Electronic Front Drive will fit in either hole—therefore be sure the
motor is on the top right side, while standing behind the X-Series.
2. Insert the Upper Caddie Structure into the top of the Chassis just behind the battery tray, and close
the draw latch. (Figure 2)
3. Fold down the Flex-Adjust Bag Support (Figure 7 on page 15) until it comes to a stop.
4. Remove the three plastic tie-wrap bands from the handle. Simply press down on each of the red tabs on the
tie-wraps that are encircling the handle grips. While pressing down on the red tab, push the extended edge
back through the locking mechanism to loosen the hold on the handle grip.
Note: Make sure the Function Switch is in the “ OFF ” position. Begin to establish the habit of putting the
switch in the “
OFF
” position while assembling your Kangaroo X-Series.
Cont: