Kanga Products Bassinet, Руководство пользователя и инструкция пользователя

Страница: 5 / 26

Rooster CW Transceiver Rev3 Page 5 of 26 22
nd
Nov 2023
Stage 1 :- The DC input socket
The first part of the build is to fit the DC socket.
The socket must be fitted so that its flush to
the board and level with the edge of the PCB,
the position for this is labelled PWR on the
board. It must be square to the edge of the
board as shown here. The silk screen printed
layout can be used to make sure it is positioned
and aligned correctly.
Solder one pin first on the bottom of the board
and checking the part is correctly fitted, once
you’re happy that it is right solder the remaining
two other pins.
Here is what you should have now.
The 3 legs are now
much too long, they
would short out
when fitted into the
case, use wire
trimmers and cut
the soldered pins
flush to the board.
Do not move on a stage until the current stage you are working on has been completed
correctly. The biggest problem identified with the beta testers was poor soldering and
rushing to get the kit built, do not take short cuts. Each part is as important as the next. Save
your self-problems later by taking care at each stage.