K&S KS 12-1E 1/3 ATSR, Инструкция

Страница: 15 / 28

14
12. ENGINE START
Before starting the engine make sure that the total power of tools or power
consumers corresponds to the rated power of the generator. Do not exceed
the nominal power of the generator. Do not connect any devices before you
start the engine!
NOTE! Do not use in single-phase and three-phase mode at the same time
! !
WARNING - DANGER!
Before connecting any devices to the generator, make sure that they are in good
working order. If the connected device suddenly stopped or failed, immediately de-
energize the device using the emergency switch, disconnect the device and check it
out.
! !
WARNING - DANGER!
Do not connect two or more devices at a time.
The start-up of many devices requires high power.
Devices should be connected one at a time according to their power rating.
Do not connect any power consumers within the first 3 minutes after the
generator has been started.
12.1. GASOLINE GENERATOR ENGINE START
1. Move the fuel valve to the “OPEN” position.
2. Turn the key to the START position and hold it in this position for a few
seconds until the engine starts.
12.2. ATS System
Generators are equipped with a universal ATS output for connecting an Automatic
Transfer Switch unit.
The ATS system allows the generator to be automatically stopped in the event of
power outage and then automatically started when the power supply is restored
without user intervention.
Fig. 9
Closed
Open
Fuel valve
ATS output
Fig. 10