* FREE K&N
®
decal To register your warranty, please see us online at knfilters.com/register. FREE K&N
®
decal *
INSTALLATION INSTRUCTIONS
Continued
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and fix as necessary.
3. If road test is fine, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
intake system’s air filter element every 100,000
miles. When used in dusty or off-road
environments, our filters will require cleaning more
often. We recommend that you visually inspect
your filter once every 25,000 miles to determine
if the screen is still visible. When the screen is no
longer visible some place on the filter element, it is
time to clean it. To clean and re-oil, purchase our
filter Recharger
®
service kit, part number 99-5050
or 99-5000 and follow the easy instructions.
ROAD TESTING:
32. It will be necessary for all K&N
®
high flow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections.
Failure to follow the above instructions or proper
maintenance may void warranty.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX 951-826-4001
• e-mail: [email protected]
®
• WWW: http://www.knfilters.com
®
31. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an
emissions inspector can see it when the vehicle
is required to be tested for emissions. California
requires testing every two years, other states may
vary.
30. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
17727D
5/07/14
24. Install the filtercharger onto the mass air
assembly as shown.
25. Reconnect the mass air sensor electrical
connection as shown.
26. Install the mass air assembly onto the intake
tube and adjust for best fit before tighting hose
clamps.
27. On vehicles with external temp sensor, install
the temp sensor onto the intake tube then re-
connect the electrical connection.
28. Reconnect the crank case vent and idle air
hose onto the new intake tube with the provided
silicone hoses as shown.
29. Re-install the engine cover that was removed
in step 2.
