Guitar Stand »Memphis«
User’s Guide
-17680.000.55- / -17685.000.55- / -17690.000.55- 8/04
STEP 7: »Memphis« 10, 20 and 30:
Reverse the above to return to original
compact folded type.
STEP 8: »Memphis« 10, 20 and 30:
You may insert your guitar pick into the
slot on the yoke.
STEP 2: »Memphis« 10, 20 and 30:
Raise main tube by lifting up lever on
the base where legs are attached, once
it gets to ideal height, push lever back
to lock.
STEP 3: »Memphis« 10 and 20:
Rotate the neck yoke forward for
holding guitar neck, it should snap into
position, unhook retention strap and
pull around to the front of yoke to
secure guitar neck.
SET UP
STEP 1: »Memphis« 10, 20 and 30:
Lift up tripod legs until hit each detent.
STEP 5: »Memphis« 20 and 30:
Adjust length of arms on front legs to fit
width of different guitars by lifting the
adjustable arms up to an angle, then
slide in the slot of fixed arm, when it
reaches ideal length, push it down to sit
in the fixed arm.
2. Don’t adjust leg arms without lifting at
an angle
3. Don’t adjust height when lever is
closed position.
STEP 4: »Memphis« 10:
Adjust height by lifting lever on the
telescoping collar, when it reaches ideal
height, push down lever to lock.
STEP 6: »Memphis« 10:
Loosen the screws that fasten
adjustable arms to each leg for moving
it up and down, then put the screws
back and tighten them together when
reach your ideal height.
Caution:
1. Never put your finger in between leg
& base when lifting legs up for
installation.
- Collapsible, compact for storage
- Easy to set up
- Great stability
- Super protection with soft material
- No tools required for installation
- No loose parts
- Easy to adjust
- Fits almost all guitars
