上海标星科技发展有限公司
K&M Technologies Ltd.
• Website
：
• Email:
• Tel: +86 0512 - 57403727
f.
Band width: frequency search scope is set together with the selection of the search
direction to get the best peak point or reduce the search time. The default factory setting
is the maximum band width.
g.
Standby resistance limit: the standby resistance limit value of the welding horn is regarded
as the judge limit for horn test, exceeding the value in ultrasonic check, it will alarm to
indicate excessive resistance.
h.
Peak voltage: it is the protection voltage limits on the two ends of the transducer. The
value shall be increased properly for frequent protection actions.
i.
Introduction frequency: this value can be increased properly when the ultrasonic system
has deviated frequency compensation or the resistance feature is not obvious on heavy-
load.
12.Factory default setting
Factory setting: the factory setting is protected by password. The password is “1234”for
user’s parameter management menu; “2005”for factory setting menu; “8080” for operation
parameter verification menu.
12.1 User’s parameter management menu
