2
SETTING UP THE DUAL CHANNEL PRO ST
PREAMP (STEREO)
1.
Remove the snap-off lid. There is no need to
undo any screws to remove the lid.
Important: Please do not tamper with the
screw on the bottom of the preamp!
2.
Insert a 9-volt battery into the designated
compartment.
3.
There is a diagram for the internal trim pot
controls on the inside of the lid. In the box
you will also find a little screwdriver for the
adjustment of the trim pots. It is attached
with a Velcro fastener.
4.
Connect your pickups to the stereo input via
a shielded
¼
” stereo cable (not supplied)
and connect MONO/MIX OUT via a mono
¼
”
guitar cable into an amplifier.
5.
If a second mono cable is inserted into CH. 2
OUT, the channels will be carried
separately. In other words, CH. 2 OUT will
carry only Ch. 2 and MAIN/MIX OUT will
carry only Ch. 1.
6.
A cable must be inserted in the MAIN/MIX
OUT in order to switch on the battery power.
7.
Set your amp to a flat setting first. Adjust the
gain trim pots of each individual channel
until both channels yield the same loudness.
Adjust EQ trim pots to your preference.
Close the lid and you are ready to go.
TECHNICAL DATA
Frequency response: 10 30,000 Hz
Inputs: 1 Mega Ohm
Output: 10 Kilo Ohm
Battery consumption: 3 Milli Amp, about 60 hours
