Travel Bike Backpack for Pet
Assembly Instructions - Page 2
K&H Pet Products, Central Garden & Pet
Colorado Springs, CO
www.khpet.com l (719) 591-6950
Made in China
CONTINUED...
K&H Pet Products with design is a registered trademark of Central Garden & Pet Company.
©2020 Central Garden & Pet Company
REV0_05-03-20
11
12
13
14
15
10
9
CARE INSTRUCTIONS:
The inside and outside of the Travel Bike Backpack can be
wiped clean with a damp cloth.
Figure 11
Figure 12
Figure 13
Figure 15
Figure 17
Figure 14
Figure 16
Finished!
Front View of Bike
Plastic Extension
Piece
IMPORTANT: At this time, the curved end of the plastic extension
piece should also rest comfortably across the curve of your bike’s
head tube. See Figure 11. TIP #1: You may need to experiment with moving
the entire plastic extension piece onto the different horizontal crossbars of the
metal mounting bracket until its curved end fits well up against the curve of your
bike’s head tube. TIP #2: You may also have to flip the plastic extension
piece upside down, (180 degrees), in order to find the right fit for your bike’s
head tube. Again, see Figure 9 for further instruction if needed.
Once the metal mounting bracket is resting on your handlebars and the extension
piece is snapped onto the mounting bracket in the proper place, hold firmly
against the handlebars and stretch one of the 3-inch rubber straps from Figure 3
around the UNDERSIDE of the handlebar. Hook one of the open holes in the
rubber strap onto the corresponding curved metal end piece. See Figure 12.
Make sure this is stretched tight. Repeat this step on the other handlebar.
Locate the supplied wrench and tighten the nut on the plastic extension piece so
that it is snug, making sure to keep its curved end in place resting comfortably
along the curve of your bike’s head tube. See Figure 13.
Now it’s time to attach the K&H Travel Bike Backpack to your bike. First tuck the
shoulder straps into the two open pockets on the back side of the backpack to
keep them out of the way and clear of your back tire. Next, undo the hook and
loop strap on the bottom of the backpack before placing it onto the rear mount.
Now you can slide the vertical bar of the bike mount into the sturdy opening on
the rear of the backpack as shown in Figure 14. Push the product down until
it’s resting on the horizontal metal support bar of the rear bike mount.
Next, grab the hook and loop strap that you just loosened on the bottom of the
backpack. Pull it tightly underneath the horizontal support bar of the bike mount
and fasten it to the hook and loop material on the other side to secure it.
See Figure 15. This will tightly hold the Bike Backpack to the rear bike mount.
Locate the nylon strap with a clasp that’s hanging from the top, back of the
Travel Bike Backpack. For extra safety and support, feed a strap above each
handlebar and then wrap under the handlebar stem until they meet. Fasten the
buckle into the clasp. See Figure 16. You may need to loosen the strap at the
buckle first and then cinch tight once they are clasped together.
Attach the adjustable lead inside the Bike Backpack to your pet’s collar or harness
to keep them securely inside of the Bike Backpack at all times.
See Figure 17.
To detach the Bike Backpack from the nylon strap attached to the
underneath handlebar stem, simply squeeze the clasp to unfasten it.
To remove the Bike Backpack simply lift the Backpack off of
the mounting bracket.
Congratulations! You and your furry friend are now ready
to hit the bike path or cruise around town in your new K&H
Travel Bike Backpack. Happy and safe riding together!
Handlebar
Stem
Bike Head
Tube