34
720P HD Vandal Proof Fixed Dome Camera
Figure 39
Set wireless detection setting parameters here: Enable detect, sensor type, deployment time, linkage alarm
output, linkage alarm output duration, E-mail sending when alarm has been triggered, linkage
snapping/recording, etc.
[Enable detect]
: Enable or disable wireless detection alarm. [Sensor type]: NO and NC mode.
[Alarm output]
: Enable or disable linkage alarm outp ut
[Alarm output duration]:
Set the duration of the linkage alarm output after being triggered (in seconds),
the range of the duration is 0~86400s.0 means that there is no limit for alarm output.
[E-mail]
: Send wireless detection alarm information to users via E-mail, details about E-mail setting please
refers to
[Network Settings].
[Snap]
: When alarm is triggered, the device SD card will be driven to snap pictures. The pictures can be
saved via E-mail sending or FTP uploading. For snapping parameters, if t he number of pictures snapped at
one time is set as 10 and the snapping interval is 1 second that means when there is an alarm, 10 pictures
will be snapped and the interval between each picture is 1 second.
[Record]
: When alarm is triggered, the device SD card will be driven to record images. The record files
can be saved via E-mail sending or FTP uploading.
After setting all the parameters, click
[save]
to make the parameters valid.
5.2.6 COM Setting
See Figure 40 for the interface of “COM Setting”:
Figure 40
[COM RS485]
: When IP camera is connected to RS485 (or RS232) communication or control device (e.g.
PTZ decoder, dome camera), the parameters of RS485 (or RS232) need to be set according to the settings
of the communication control device ( address, protocol, baud rate), and the corresponding protocol need
