5
Kamstrup A/S • 55121312_E1_GB_09.2015
OMNIPOWER – single-phase
Installation manual
Terminals OMNIPOWER
OMNIPOWER ST-meter
Multi-core 7-core
Massive / terminals
Multi-
core
7-core
35 mm
2
≥ 6 mm
2
≥ 6 mm
2
≥ 2.5 mm
2
> 6 mm2 > 6 mm2
Screw: Pz 2 or straight slot
Screw:
Pz 2 or straight slot
Torch:
2.5 – 3 Nm
Torch:
3 – 3.5 Nm
Load control, installation
For meters with load control relay(s). Due to the delay in the meter, it is important to re-
start the meter (off/on) when the time is set correctly in the meter. This places the relays
in the correct position and stops the delay timer.
With built-in radio
If the meter is supplied with integral radio for establishment of remote reading, the meter
automatically starts to connect to a radio network. The integral radio is equipped with an
internal antenna. The radio signal strength can be read via the system. If the radio signal
is not sufficient, an external antenna must be connected. Please see current documen-
tation on available antennas.
Mounting a communication module in the meter may influence the radio communica-
tion. Please contact Kamstrup A/S.
With disconnect function
With this type of meter, it must be checked that the red diode is switched off. This indi-
cates that the consumer’s supply is disconnected.