Kampmann PowerKon QE, Руководство по сборке

Страница: 6 / 28

PowerKon QE
Assembly instructions
6
4 Installation and wiring
4.1 Requirements governing the installation site
Only install and assemble the unit if the following conditions are met:
Make sure that the unit is securely suspended/standing.
Ensure that the airflow can circulate freely.
There is a power supply on site.
4.2 Installation
2 people are needed to install the unit.
CAUTION!
Risk of injury from sharp metal housing!
The inner metal of the casing can have sharp edges.
Wear suitable protective gloves.
IMPORTANT NOTE!
Install connections in the de-energised state!
Connections must be installed without tension!
Use a suitable tool to protect terminal nuts from being sheared off and
twisted.
Dimensions
Dimensions of the PowerKon QE
1 Window side 2 Room side
A 825 mm // 1250 mm // 1700 mm B 400 mm // 835 mm // 1270 mm
Fixing points
All dimensions in mm
1) Upper edge of finished floor
22
4.2.
1
Fitting the grille
High surface temperatures occur at the electric heating coil. For this reason, additional grille fix-
ings are factory-fitted on both longitudinal sides of the duct as a safety guard. They can be re-
moved using a screwdriver. The grille fixing only needs to be removed on one side, the electrical
connection side, when wiring. Once wiring has been completed, attach the grille fixing again as
per the figure.
Installation of the roll-up grille
CAUTION: Do not cover the roll-up grille when the units are in operation!
5 Pre-commissioning checks
Before initial commissioning, check whether all the necessary conditions have been met so that
the unit can function safely and properly.
Electrical tests
Check whether all lines have been properly laid.
Check whether all lines have the necessary cross-section.
Are all wires connected in accordance with the electric wiring diagrams?
Is the earth wire connected and wired throughout?
Check all external electrical connections and terminal connections are fixed in place and
tighten if necessary.
Check whether DIP switches have been correctly set in accordance with the wiring diagram.