Kambrook KFP600, Инструкция пользователя

Страница: 15 / 32

14
NOTE:
The Blender is not
recommended for blending
dry ingredients.
NOTE:
If ingredients stick to the
sides of the Blender jug during
blending, turn the control dial to
the ‘OFF’ position, switch off at
the power outlet, remove the lid
and push the food back onto the
blades using a plastic spatula
to scrape down the sides of the
Blender jug. Replace lid, turn
power on at the power outlet
and recommence blending.
NOTE: The Blender jug is
designed so that the motor
will not operate without the
jug correctly locked into
position. In the event that the
appliance starts without the jug
correctly locked into position,
immediately disconnect at the
power outlet and return to your
local Kambrook Service Centre
for examination.
Disassembling the Blender Jug
1.
With one hand on the motor base
and the other on the Blender
jug handle, turn the Blender jug
clockwise.
2. Lift the Blender jug away from the
motor base to remove.
3.
Twist lid either right or left until the
spout cover is no longer aligned
with the jug spout and lift upwards
to remove from jug.
Overload Protection System
The motor is protected from burning
out by a manual reset cut-out
switch. If the processor or blender is
overloaded or operated continuously
for too long, the motor may overheat
and stop. To operate the processor
or blender again, you must switch
off, unplug and allow to cool for
approximately 30 minutes. Once the
motor has fully cooled, it is ready for
use again. Some stiff mixtures, such as
dough, may cause the dough blade
to rotate more slowly than normal.
Do not operate the appliance
continuously with an excessive load
for more than 1 minute. If this occurs
again, the processing bowl may be
overloaded, so remove some of the
food and process in smaller batches.
Assembly and Operation of Your Kambrook
Food Processor
continued