manualshive.com logo in svg
background image

5

•  This heater has hot and arcing or sparking parts 

inside. Do not use in areas where petrol, paints, 

aerosols, or other inflammable substances are 

used or stored. 

•  Do not allow materials that have been in contact 

with oil, petroleum based products or drying fluids 

to come in contact with the heater. 

•  To disconnect heater switch the power On/Off 

switch to OFF, then switch off at the power outlet 

then remove plug from its outlet. 

•  Do not insert or allow foreign objects to pass 

through the inlet or outlet openings. This may 

cause an electric shock, fire or damage  

the heater. 

•  To prevent a possible fire or heat damage, allow 

ample space around the heater (at 1.7m at front 

and 0.5m at the rear, top and sides) and do not 

totally or partially block the air inlet or outlets in 

any manner. Check the openings from time to 

time for accumulated dust. Ensure long shag 

carpet does not obstruct airflow under the unit.

•  Do not touch hot metal surfaces. 
•  Switch off at the power On/Off switch and power 

outlet, then unplug and allow heater to cool 

down before cleaning or storing. 

•  Do not use outdoors. This heater is not intended 

for commercial use such as construction sites.

•  Use this heater only as described in this instruction 

manual. Any other use not recommended by the 

manufacture may cause fire electric shock or 

injury and voids all warranties. 

•  Regularly inspect the supply cord, plug, control 

settings, air inlets and outlets and main housing 

for any damage. If found damaged in any way, 

immediately cease use of the heater and return 

to Kambrook or an authorised service agent for 
inspection or repair. 

NOTE:

 This Kambrook Ceramic 

Heater is electronically 

controlled and will not operate 

until the heater is plugged into 

a 230V or 240V power point and 

switched on.

Important Safeguards For All Electrical 

Appliances

•   Carefully read all instructions before operating the 

appliance and save for future reference.

•   Remove and safely discard all packaging 

material and promotional labels before using the 

appliance for the first time.

•   Fully unwind the power cord before use.
•   Do not let the power cord hang over the edge of 

a bench or table, touch hot surfaces or become 

knotted.

•   To protect against electric shock, do not immerse 

the power cord, power plug or appliance in water 

or any other liquid, unless it is recommended in 

the cleaning instructions.

•   The appliance is not intended for use by persons 

(including children) with reduced physical, sensory 

or mental capabilities, or lack of experience 

and knowledge, unless they have been given 

supervision or instruction concerning use of the 

appliance, by a person responsible for their safety.

•   Children should be supervised to ensure that they 

do not play with the appliance.

•   It is recommended to inspect the appliance 

regularly. Do not use the appliance if the power 

supply cord, plug, connector or appliance 

becomes damaged in anyway.  Return the entire 

appliance to the nearest authorised Kambrook 

Service Centre for examination and/or repair.

•   Any maintenance other than cleaning should 

be performed at an authorised Kambrook 

Service Centre.

•   This appliance is for household use only. Do not 

use this appliance for other than its intended use. 

Do not use in moving vehicles or boats.  

Do not use outdoors. 

Misuse may cause injury.

•   The installation of a residual current device (safety 

switch) is recommended to provide additional safety 

protection when using electrical appliances. It is 

advisable that a safety switch with a rated residual 

operating current not exceeding 30mA be installed 

in the electrical circuit supplying the appliance. See 

your electrician for professional advice

•   Always turn the appliance to the OFF position, 

switch off at the power outlet and unplug at the 

power outlet when the appliance is not in use.

•   Before cleaning, always turn the appliance to 

the OFF position, switch off at the power outlet, 

unplug at the power outlet and remove the 

power cord, if detachable, from the appliance 

and allow all parts to cool.

•   Do not place this appliance on or near a heat 

source, such as hot plate, oven or heaters. 

•   Position the appliance at a minimum distance 

of 20cm away from walls, curtains and other 

heat or steam sensitive materials and provide 

adequate space above and on all sides for air 

circulation. 

Содержание KCE95













Отзывы: