Kamasa Tools is a trade mark of KG Knutsson AB, SE 191 81 Sollentuna, Sweden, Phone +46 8 92 30 00 www.kamasatools.com
7
Fig 1
Fig 2
Fig 3
Operating instructions
installing or removing Battery Pack
(See Fig.1 Fig.2)
1. Always switch off the machine before insertion or removal of the
battery pack.
2. To remove the battery pack, push the button on the battery pack and
pull the tool unit from the battery pack in the direction.(See Fig.1.)
3. To insert the battery pack, align the tool unit slides with the battery pack
sliding groove and push the tool unit into place. (See Fig.2)
4. Do not force the battery pack in sliding it into tool unit. If the battery pack
does not slide in easily, it is not being inserted correctly.
Charging The Battery Pack
(See Fig.3)
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown
on the charger.
3. Push the battery pack into place and make sure the red light on the
charger is “ON”. The battery pack is now starting the charging cycle.
4. After finish the charging cycle, the light will turn into green. The battery
pack is now ready for use.
5. Your new battery pack is not charged. You need to charge it before use.
6. If you try to charge a battery pack from a just-operated machine, some-
times the charging light will not come on. If this occurs, let the battery
pack cool for a while then re-insert it and try to charge again.
7. When you charge a new battery pack or a battery pack which has not
been used for a long period, it may not accept a full charge. This is a
normal condition and does not indicate a problem. You can recharge the
battery pack fully after discharging it completely a couple of times.
8. While charging the second battery, allow the charger to cool down for
15 minutes before start the second charging process.
9. Unplug the charger from the power source after finish the charge.
