Operation
When laser is powered on, LED display on the rear panel shows the current operating status.
With help of LED display panel, it is very easy to set and change the operating mode of laser.
Key lock
Located on the rear panel is the safety key lock, when in the on position the laser will function correctly. When in the off position
the laser diodes will not function but the unit will still power up.
Remote socket
This can be connected to a remote safety lock off switch if required (not supplied).
Mode
Mode/Function Option, to choose the operating mode of laser.
Enter
Confirmation, to confirm all settings or change of LED control panel.
UP/DOWN
to change operating mode, parameter or DMX address.
Stand alone mode
Using the function button press until one of the following is displayed Sra,Ara,Asr, and is flashing
Use the up / down buttons to select desired program
Press enter to confirm
DISPLAY
STAND ALONE MODE PRE PROGRAM EFFECT
ARA
A
uto Running
rA
ndom Effect
ASR
A
uto
S
low
r
unning Effect
SRA
S
ound Activated
rA
ndom Effect
MASTER/SLAVE MODE
Several units can be linked together using a DMX cable (not supplied). This can be done with or without a DMX controller.
Stand alone (no controller)
One unit must be set as the master unit, using the function button select the desired program. All other units must be set to slave
mode, using the function button until
SLA
is displayed, then press enter to confirm. This must be done on all slave units.
And they must be linked together using a 3pin XLR to XLR DMX cable.
Connect from the DMX output of the master into the DMX output of the first slave device and continue linking in this way to all
other slave units.
In sound mode use the rotary dial on the rear panel to adjust the sound sensitivity.
Linking with DMX controller
Each unit uses 8 DMX channels. Using the function button press until 001-512 is displayed. Using the up/down button select the
required DMX starting address and press enter to confirm. This will start the DMX address at 001. If wanting to control several
units exactly the same, all units must be set to this start address. If wanting individual control of all units, each unit must have its
own starting address. E.g. unit 1 set to 001 unit 2 set to 009 and so on. Each unit must be set at least 8 channels apart and no
channel address must cross over with another unit.