STEREO OPERATION
Connect the audio signal (e.g. music) to the inputs (16).
Set the operation mode switch (13) to Stereo.
Connect the matching speakers to the L+R Speakeron outputs (11).
Set both input gains (2) to zero.
Make sure that there is an audio signal.
Turn the amplifier On (8).
Adjust the input gains (2) to the desired level.
BRIDGE OPERATION
Connect the audio signal (e.g. music) to the CHA input (16).
Set the operation mode switch (13) to Bridge.
Connect the matching speaker(s) to the Bridge output (12).
Set both input gains (2) to zero.
Make sure that there is an audio signal at the CHA input.
Turn the amplifier on (8).
Adjust the CHA input gain (2) to the desired level, leave the CHB channel gain at zero.
MONO OPERATION
Connect the audio signal (e.g. music) to the CHA input (16).
Set the operation mode switch (13) to Mono.
Connect the matching speakers to the L+R outputs (11).
Set both input gains (2) to zero.
Make sure that there is an audio signal at the CHA input.
Turn the amplifier on (8).
Adjust the CHA input gain (2) to the desired level, leave the CHB channel gain at zero.
TECHNICAL SPECIFICATIONS
Model
KXD3200
KXD4400
KXD6000
KXD7200
8
Ω
400w RMS+400w RMS
550w RMS+550w RMS
750w RMS+750w RMS
900w RMS+900w RMS
Stereo
4
Ω
1600w+1600w
800w RMS+800w RMS
2200w+2200w
1100w RMS+1100w RMS
3000w+3000w
1500w RMS+1500w RMS
3600w+3600w
1800w RMS+1800w RMS
Output power
EIA 1KHZ 1% THD
Bridge
8
Ω
1600w RMS
2200w RMS
3000w RMS
3600w RMS
Frequency range
5-36KHz / -0.5dB,
Input Sensitivity
26dB / 32dB / 1.4V
S/N Ratio
≥
100dB
Distortion (typical)
Less than 0.04%
Distortion (SMPTE)
Less than 0.04%
Input Impedance
10Kohms unbalanced, 20Kohms balanced
Damping Factor (5Hz-1KHz)
≥
280
Slew Rate
29V/uS
Crosstalk @ Rated Output 8
Ω
1KHz
A-B 75dB , B-A 90dB
Protection
Soft start, DC, AC, short circuit, clip limiter, thermal cut, power limiter
Dimensions (W*D*H)
482 x 334 x 44 mm
N.W.
5.6 Kg
5.6 Kg
6.0 Kg
6.0 Kg
Mains Power Supply
110V AC 60Hz / 240V AC 50Hz
The Kam KXD series amplifiers are designed for single voltage only. Please ensure that the unit matches your local power supply.
