Master unit: When dipswitch 1 is set to ON, all the units will run with the auto program.
Master unit: When dipswitches 1 and 2 are set to ON, all the units run with auto animation.
Important note:
1. Link no more than 5 units together at one time.
2. Before setting master slave function, you must turn off all the lasers in one link. Once you have set the dipswitches,
you can then turn the units on. If you are going to change the master unit and slave unit, you should again turn off all
the lasers before making the changes.
Universal DMX Operation (DMX mode)
This mode allows you to use universal DMX-512 console to operate the unit. Install the units in a suitable position.
Use standard XLR cable to connect your units together via the XLR connector on the rear of the units. For longer
cable we suggest a terminator at the last fixture. Assign a DMX address to each the unit using the dipswitches. Turn
on the units then use the DMX console to control all your units.
Instruction for DMX channels
Channel
Mode
Value
Function
CH1
Mode select
0~49
Sound active mode
50~99
Auto-beam mode
100~149
Auto-animation mode
150~199
Static patterns
200~255
Dynamic Patterns
CH2
Color select
0~255
0 is LASER OFF, the rest to change colors
CH3
Pattern select
0~255
Selecting patterns
CH4
Y axis moving
0~127
Manual up to down moving
128~191
Auto down moving (under dynamic pattern)
192~255
Auto up moving (under dynamic pattern)
CH5
X axis moving
0~127
Manual left to right moving
128~191
Auto right moving (under dynamic pattern)
192~255
Auto left moving (under dynamic pattern)
CH6
X axis rolling
0~127
Manual rolling
128~255
Auto rolling (under dynamic pattern)
CH7
Y axis rolling
0~127
Manual rolling
128~255
Auto rolling (under dynamic pattern)
CH8
Rotation
0~127
Manual rotation
128~191
Auto counter-clockwise rotation (under dynamic pattern)
192~255
Auto clockwise rotation (under dynamic pattern)
