9
5. Installation
Do not exceed the electric and temperature ratings printed on the dataplate located on
the lower right back side of the unit.
CAUTION!
Improper operation of the equipment could result in dangerous conditions.
To preclude hazard and minimize risk, follow all instructions and operate
within the design limits noted on the dataplate.
5.1 Location
Install the unit in a level area free from vibration with a minimum of fifteen
centimeters of space on the sides, rear, and top. Refer to Section 5.3 for further
instructions on leveling cabinets. Allow enough clearance so that door or lid can
swing open at least 90 degrees.
Do not position the equipment in direct sunlight or near heating diffusers, radiators, or
other sources of heat. The ambient temperature range at the location must be 15 to
32
o
C.
WARNING!
Install the unit on a sturdy floor. If the floor is not strong enough or
the installation site is not adequate, this may result in injury from the
unit falling or tipping over.
WARNING!
Never install the unit in a flammable or volatile location. This may
cause fire or explosion.
Never install the unit where acid or corrosive gases are present as
current leakage or electric shock may result due to corrosion.
WARNING!
Do not use outdoor. Current leakage or electric shock may result if the
unit is exposed to rain water.
Never install the unit in a humid place or a place where is likely to be
splashed by water. Deterioration of the insulation may result which