＜
CAUTION
＞
●
Use a container without detergent, soap, chemicals, and oils to soak the photocatalyst filter.
●
When the photocatalyst filter is not attached back correctly, the power light flashes and beeps. Please try again.
●
Cleaning the photocatalyst filter
●
Remove from wall
More than
10cm
3
Air dry under the sun
1
Remove the photocatalytic filter
It beeps five times, and the power turns off.
2
Soak the filter for approx. 10 hours
.
4
Beep, beep
… 5 times
Power
lamp
How to Care and Maintain
2
Remove the front panel
Refer to procedure 1 "Pre-filter (Air suction vent )
care”(
→Page
11
)
3
Remove the AC adapter from the main unit and
take out the screw from the bottom of the main
unit
1
Turn off the power and disconnect the power plug
from the outlet. Please refer to “4 Power off”
(→Page
9
)
①
①
4
Remove the main unit from the
fixing angle(back panel)
①
Pull the bottom part of the main unit to detach from the
fixing angle.
②
Lift the unit slightly and pull up the hook from the fixing
angle.
②
②
hooks
Rinse the dust on the surface of the photocatalyst filter.
12
Attach the photocatalyst filter and turn the power on.
WARNING: Do not scrub the filter as the
photocatalyst elements may be damaged
Only use water or warm water
