Attention.
The container in which the Photocatalytic filter is soaked should be free from detergent, soap, chemicals, and oil.
If the louvers are not installed correctly, the power lamp will blink and you will need to reinstall them.
More than 10cm
* Use a 45L dust box as a
container, it will be a best fit.
Do not scrub the filter
●
Cleaning the Photocatalyst filter
3
Remove the Photocatalytic filters (4 pcs)
When power is on
5
Air dry in the sun
Only to use water or lukewarm water
Do not use detergent or
soap! Do not disassemble
the Photocatalytic filter!
Hold the handle.
Remove them one
at a time.
Approx. 4
～
5 hours
Allow them to dry
thoroughly.
4
Soak the filter for
approx. 10 hours.
6
Put the photocatalytic filters (4 pcs)
1
Turn off the power.
Press the end to remove the Top panel cover.
※
This is natural bamboo, be careful of thorns.
7
Put the louvers (2pcs) and the Top panel cover
and turn on the power.
Rinse the dust on the surface of the Photocatalyst filter.
Rinse all 4 filters at once.
Power lamp
flash... (5 times)
How to Care and Maintain(continued)
①
②
The photocatalyst may come off.
12
2
Remove the louvers.
