KALOS KLFP211-0200, Руководство по сборке

Страница: 8 / 20

Safety Warnings
•
NEVER
use an LP gas tank with a damaged
body, valve, collar, or footing. Dented or
rusted LP gas tanks may be hazardous and
should be checked by your LP gas supplier
prior to use.
• The LP gas tank should not be dropped or
handled roughly.
• Tanks must be stored outdoors out of the
reach of children. Do NOT store in a building,
garage, or any other enclosed area.
• Never store your LP gas tank where
temperatures can reach over 125°F.
•
DO NOT
store the LP gas cylinder in
direct sunlight or near a source of heat
or combustion.
• Never keep a filled LP gas tank in a hot car
or car boot. Heat will cause the gas pressure
to increase, which may open the relief valve
and allow gas to escape.
• Place dust cap on valve outlet whenever the
LP gas tank is not in use. Only install the type
of dust cap on the LP gas tank valve outlet
that is provided with the LP gas tank valve.
Other types of caps or plugs may result in
leakage of propane.
• DO NOT store a spare LP gas cylinder under
or near this appliance.
• Never fill the LP gas cylinder beyond
80% full.
• If the information in this booklet is not
followed exactly, a fire causing death or
serious injury may occur.
• LP gas cylinders should be filled only by a
certified LP gas dealer.
• the pressure regulator is set for 28-30mbar
or 50mbar.
• Regulator outlet pressure is 28~30mbar
or 50mbar.
• Never attempt to attach this appliance to the
self-contained LP gas system of a camper
trailer, motorhome or house.
• Always use the pressure regulator and hose
assembly provided with the appliance to
connect to a LP gas cylinder. Never connect
to an unregulated LP gas supply.
• Contact your retailer’s customer service
department for replacement parts.
• Hand turn the manual gas control valve.
Never use tools. If the valve will not turn by
hand, do not try to repair it. Call a certified
gas technician. The use of force or any
self-attempted repair may result in a fire
or explosion.
• Use only the type of gas and the type of LPG
cylinder specified by the manufacturer.
• Appliance is fitted with gas regulator, flexible
gas rubber pipe and clamps according to
the National Rules in force of the country
of destination.
• Appliance must use an approved gas
regulator (approved for a working
temperature not lower than 50˚C) according
to the EN Standard (see minimum, nominal
and maximum pressure - gas regulator
inletand outlet connection according to the
National Rules in force) and flexible gas hose
according to ENStandard (with proper inner
diameter according to gas inlet connection
and National Rules in force)with a length