Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
Print only
what is inside the frame.
6
PPG 36584 - 120501
Assembly page 6/26
Fax +1 305 430 9692
USE
•
With a spice container attached to the motor block, hold the
appliance above the meal to season.
•
Press on the grind switch.
•
A LED light underneath each mill enables you to see how much
you are grinding, for a more precise seasoning.
•
Interchange the spice containers at will, season to taste.
MAINTENANCE
•
Disassemble the different parts of the appliance (housing,
containers, lids) and clean them separately with a damp cloth.
•
Do not immerse the motor block in liquid or put it in a dishwasher.
•
Do not use with wet hands.
•
Do not use cleaning products or detergents.
•
Only use with the adapter supplied or of the same type (Input:
AC 110V 60Hz, Output: DC 5V 300mA)
TROUBLESHOOTING
If the mill does not grind, or if no motor noise can be heard, please
check that the batteries are not discharged. Recharge if necessary.
If the mill gets stuck during use (motor produces hum, but internal
shaft does not turn and no pepper is ground], check the container is
properly installed, then gently shake the mill or tap the mill gently on
a hard surface, to remove the stuck pepper or salt.
To remove deeply stuck peppercorn, remove the upper lid as if for
re-filling the mill, turn the coarseness setting to its coarsest, and tap
lightly on a hard surface until all the peppercorn is released. Re-
adjust coarseness setting to the desired level once done and
replace upper lid.
Note: Too fine a grind setting may not enable salt or pepper to be
ground. If the case, set the grinder to a coarser setting (see above).
