7
USK BL 24242/BL 25280 - 071214
Manual Speed setting
Turn the rotary knob from “MIN” position to “MAX” position to
select the desired speed. The blender runs from low speed to high
speed.
In manual speed setting, the “ice button”, “smoothie button” and
“pulse button” are disabled
•
Blender stops running if the current is above the limitation and the
pilot light of “pulse button” flashes, press “pulse button” again
and the appliance resume working.
•
No matter in what mode the blender is working, just lift glass jug
from the motor block to stop the appliance. To resume operating
the blender,
set the speed rotary knob back to “off” position
,
replace the jug, select the “On” position and choose the function
or turn the rotary knob to select speed.
HOW TO CLEAN
•
Always unplug from outlet before cleaning.
•
For a quick rinsing of the pouring jar (for example between two
preparations), you can use clear water and switch on your
appliance for a few seconds. In this case, do not use any
detergent.
•
For a full cleaning of the pouring jar, remove it from the motor
block and unscrew the base of the blade assembly by turning it
anti-clockwise to disassemble it (this will make the cleaning
easier). Then you can clean the blades and the jar with soapy
water and rinse thoroughly with clear water. Dry before
assembling. Therefore you only have to screw the blades support
by turning it clockwise in the bottom of the pouring jar (tighten
vigorously in order to avoid leaks). Attention, do not lose the
sealing ring during this operation.
•
You can wipe the motor block with a soft damp cloth.
