6
Preliminary checks
Before switching on the pellet Insert, make sure that the pellet hopper is full, the combustion chamber is clean, the glass door
is closed, the power supply plug is connected and the switch on the back is set to “1.”
21 : 10
22°C P-1
TURNED OFF
14 : 35
22°C P-1
FIRE
present
14 : 35
21°C P-2
LOAD
pellet
15 : 18
22°C P-3
WORK
TURNED OFF
The Insert is off.
TURNED ON
The Insert is in the fi rst ignition
phase. The glow plug and fume
extractor are active.
LOAD PELLET
In this phase of the ignition process
the Insert starts loading the pellets
into the brazier. The glow plug, the
fume extractor and the cochlea
engine are active.
FIRE PRESENT
In this phase of the ignition process
the Insert starts loading the pellets
into the brazier. The fume extractor
and the cochlea engine are active.
BRAZIER CLEANING
The Insert is cleaning the basket.
The smoke extractor runs at
maximum speed and the pellet
load is at minimum.
WORK
The Insert is working, in this case
at power 3. The detected room
temperature is 21 ° C. During
normal work, the fumes fan, the
auger motor and the room fan are
active.
14 : 35
21°C P-2
ACCENDE
ON STAND BY
All the requests have been
satisfi ed and the insert is ready for
the “STAND BY” mode.
HOLD REQUEST
The insert is in a “STAND BY”
mode as everything has been
satisfi ed. The insert is waiting for
an heating request to turn on.
WAIT COOLING
The insert has to complete the
cooling circle before turning on
again.
21 : 10
22°C P-1
STAND BY
14 : 35
21°C P-2
HOLD
REQUEST
14 : 35
21°C P-2
WAIT
COOLING
15 : 18
22°C p-2
BRAZIER
CLEANING
7.0 Display information
ATTENTION!
The insert will function during the hours of ON programming at
the same temperature and the power settings as when it was last
shut down.
!
EN
Содержание Paola 13
Страница 22: ...20 NOTE Cod 001030A EN...