Kalmar Ottawa t2, Руководство по обслуживанию, Страница: 23 / 262

14 0.4 Preventive Maintenance Technique – C. Preventive Maintenance
Maintenance Manual Ottawa T2 4x2
• Defroster Operation
With the engine running and the defroster control
turned on, confirm air flow from the defroster vents.
• Air Conditioner Operation
With the engine running and the air conditioner con-
trol turned on, confirm cooled air flow from the
vents.
• Auxiliary Fan(s) (if applicable)
With the key on, turn on the auxiliary fans and con-
firm operation.
Check 5th Wheel Unlatch Control — With system air
pressure above 100 PSI confirm that the 5th wheel jaws un-
latch when the dash control is activated.
Check Operation of Boom — With the engine running at
fast idle activate the boom control and ensure full extension
and retraction.
Check Operation of Windows — Confirm that all regulat-
ed and sliding windows open and close fully.
Check Seat Belt Operation — Ensure that the seatbelt
latch fastens and unfastens properly.
Check Rear and Side Door Latch Operation — Operate
the side door latch from inside and outside the cab to en-
sure proper operation.
Check Dome Light Operation — With key on, turn on cab
dome light and confirm operation.
Check all Glass and Mirrors — Inspect all glass and mir-
rors for cracks and breaks
Check Fire Extinguisher Charge (if applicable) — If the
vehicle is equipped with a fire extinguisher confirm that it is
properly charged.
page –
Seat Belt System
Inspect the seat belt system every 20,000 miles (32,187 km) or
more often if exposed to severe environmental conditions or
vocation. Check the following:
Inspect belt on entire system for cuts, fraying, extreme or
unusual wear. Most common areas of belt wear include the
buckle/latch area, the shoulder loop area and any place
where the belt makes contact with vehicle or seat. Replace
the entire belt system if necessary.
Inspect buckle for proper operation by inserting latch and
listening for an audible click. Verify the buckle is not dam-
aged, cracked or broken. Replace the entire belt system.
Inspect buckle cable (optional component) black coating
on buckle cable must not be damaged. Internal cable wires
must not be exposed, frayed or broken. Replace the entire
system.