INSTALLATION INSTRUCTIONS
Vanity
1207801-2-
B
© 2013 KALLISTA
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
7 of 8
5. ReMOVe/ADjUST The DOORS AND hINgeS
Vertical
Gap
Horizontal
Side of Vanity
Top of Door
Hinge Base
Latch
Bracket
Slot
Hinge Cup
Removal:
At each hinge assembly location on the door, hold the door in place with one hand while releasing the latch
from the bracket. The door will detach from the hinges. Set the door aside.
If applicable, remove the remaining door in the same manner.
Replacement/Reinstallation:
Line up the latch pin on the hinge cup with the groove on the hinge base and then snap into place.
Open and close the door to confirm smooth operation. Adjust the screws on the hinge assembly as needed.
Adjustment:
NOTe:
Refer to the hinge assembly illustration above to select the screw that corresponds to the adjustment
needed.
Vertical (up or down)
– Turn the screw either way on the bottom and top hinge assembly until the desired
adjustment is achieved.
horizontal (left or right)
– Turn the screw either way on the bottom and top hinge assembly until the
desired adjustment is achieved.
gap (in or out)
– Loosen the screw on the bottom and top hinge assembly, hold the door in the desired
position, and then retighten the screws.
