INSTALLATION INSTRUCTIONS
Wooden Vanity & Pre-Cut Marble Top
1158696_2_A
4 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
3. MARBLE TOP HOLE FABRICATION (OPTIONAL)
Three faucet holes have been partially drilled from the underside of the console top.
On the top, show surface, of the console top, locate the center of the required faucet holes. Using a
compass or circle template, draw a circle for the required holes.
Using a small hammer, create the faucet hole(s) by gently tapping the console top within the circles until the
marble breaks away.
NOTE: DO NOT
strike the console top with too much force.
DO NOT
strike from the bottom side of the console
top. This will damage the top surface of the console top.
Using a file or sanding cylinder, complete the removal of marble material to create a clean round hole.
4. INSTALL THE MARBLE TOP
Stone Vanity Top
Wooden Vanity Cabinet
Apply clear 100% silicone
caulk or sealant.
NOTE:
If using a lavatory with overflow, ensure that
the lavatory is installed with the overflow to the front
of the marble top and vanity.
Install the lavatory and faucet to the marble
vanity top at this time. Refer to the lavatory
manufacturer’s instructions for proper lavatory
installation. Refer to the faucet manufacturer’s
instructions for proper faucet installation.
With the help of an assistant, place the marble
vanity top on top of the wooden vanity cabinet.
Verify correct fit and alignment of all components.
Adjust as necessary.
With the help of an assistant, carefully remove
the marble vanity top and set aside.
Drill two pilot holes through the mounting rail
and finished wall on each side of the wooden
vanity cabinet. Make sure the two pilot holes are
spaced a minimum of 16″ (40.6 cm) apart from
one another.
Tighten a wood screw through each of the two
drilled holes until the wooden vanity cabinet is
flush and secure against the finished wall.
Apply clear 100% silicone caulk or sealant to the
top of the wooden vanity cabinet.
With the help of an assistant, replace the marble
vanity top on top of the wooden vanity cabinet.
Verify correct fit and alignment. Adjust as
necessary.
