Kallista P50047-G5, Руководство по установке

Страница: 18 / 28

INSTALLATION INSTRUCTIONS
60" x 32" Acrylic Air Bath
1107630-2- C
18 of 28
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
INSTALL THE POWER CORD AT THE CONTROL - REMOTE (CONT.)
 Connect a solid copper 8 gauge bonding wire from the bonding lug on the new junction box to the spare
bonding lug on the control. Follow all local electrical codes.
Reconnect the Blower Motor Power Cord

If required, reconnect the blower motor power cord at the control.

Route the power cord through a strain relief on the new junction box. Tighten the strain relief.

At the end of the cut power cord, strip back the cable jacket about 3” (76 mm).
 Cut the unused brown conductor off at the cable jacket and cap off with a wire nut.
 Strip the wire insulation about 3/8” (10 mm) from the end of the wires.
Terminate the New Power Cable

Route the new power cable through the other strain relief on the new junction box. Tighten the strain relief.

Strip back the cable jacket about 3” (76 mm).

For installations in the United States, mark white conductors with red or black tape as required by the NEC.

Strip the end of the wires about 3/8” (10 mm).

Use approved termination devices to terminate the conductors as follows:
●
Connect the black pigtail lead to the L1 conductor of the power cable.
●
Connect the blue pigtail lead to the L2 conductor of the power cable.
●
Connect the green with yellow stripe pigtail lead to the grounding/earthing conductor of the power cable.

Install the cover on the new junction box.
12. INSTALL THE PLUMBING - REMOTE
CAUTION: Risk of property damage. A watertight seal must exist on all bath drain connections. The
watertight seal will prevent property damage.
NOTE: To simplify future maintenance, provide access to all plumbing connections.

Loosely make connections between the bath and over fl ow and the drain to the bath. Con fi rm locations and
adjust as needed.

Tighten connections between the bath and over fl ow, drain to bath, and drain assembly to trap according to
the drain manufacturer’s instructions.

Con fi rm drain assembly connections are snug according to the drain manufacturer’s instructions.

Install the faucet valving according to the faucet manufacturer’s instructions. Do not install the faucet trim at
this time.
 Open the hot and cold water supplies. Check all connections for leaks.
 Fill the bath to the over fl ow. Check the drain connections for leaks. Repair as needed.