1085231-2-A
Page 2 of 3
P23010
Floor Riser Support Assembly
2. ATTACH THE PIPE HOLDERS TO THE FLOOR RISERS
3. CUT THE CONNECTING ROD TO SIZE
Carefully slide the straight end of the floor riser through
the pipe holder and the flange.
Thread the floor riser into the supply rough-in and tighten
it with a strap wrench.
Adjust the flange so that it rests on the floor. Tighten the
set screw.
Repeat for the second floor riser.
Slide the pipe holders and tee bracket up the floor risers
to the desired position, being careful not to scratch the
floor risers.
NOTE: To prevent damaging the tub, the floor riser
support assembly should be mounted a minimum of
12” from the floor.
Tighten the set screws.
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALLATION INSTRUCTIONS
Set Screw
Set Screw
Floor Riser
Floor Riser
Set Screw
Pipe Holder
Tee Bracket
Pipe Holder
Flange
Measure the distance from the end of the tee bracket to
the tub. Add 3/4” to this distance. This is the length of
the connecting rod.
Add 3/4” to this
distance
1
2
3
4
5
6
7
8
9
Mark this distance on the connecting rod, measuring
from the end with the ball toward the end with the hole.
Use a hacksaw to cut off the connecting rod at the
mark, being careful not to scratch the finish of the
connecting rod.
Remove any burrs or sharp edges.
