INSTALLATION INSTRUCTIONS
Slidebar
1238521-2-C
4 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
2. INSTALL THE SLIDEBAR WITH INTEGRATED SUPPLY (P21664)
29-7/8"
(759 mm)
1/4"
(6 mm)
Hole
Anchor
Bracket
Supply
Adjustment
Screws
Setscrew
Back View
Setscrew
Top Post
NOTICE: These instructions are for P21664 (with integrated supply). For P21654, proceed to the next section.
Measure and mark 29-7/8” (759 mm) vertically from the center of the adapter.
Make sure the top post adjustment screws are centered in their slots so adjustment can be made in either
direction. This will allow even up or down adjustability of the slidebar top post.
Hold the slidebar up and make sure the openings in the two posts are centered on the mark and adapter.
Using a level, verify that the hole centerlines are vertically aligned.
Drill a 1/4” (6 mm) hole at the marked location, and install the wall anchor fl ush to the wall.
Mount the bracket to the wall with the supplied screw.
Position the slidebar with the water supply at the bottom. Push the slidebar onto the two brackets.
If necessary, adjust the vertical position of the top post: Using a 3/32” hex wrench, loosen the four screws
and adjust the top post position. Retighten the screws.
The hole in the bracket is oversized to allow for additional adjustment if necessary for proper fi t. Loosen the
screw and adjust the bracket up or down slightly. Then retighten the screw.
Using a 3/32” hex wrench, secure the setscrew at each post.
Turn on the water supply and check for leaks. Repair as needed.
Apply silicone sealant around the perimeter of the two posts.
Wipe away any excess sealant.
