INSTALLATION INSTRUCTIONS
Kallista Bath Flip Drain
1117993_2_A
Page 7 of 7
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALL THe wASTe ANd OveRFLOw (CONT’d)
Secure the Tailpiece into the P-trap
Wrench tighten the P-trap compression fitting to one quarter turn past hand-tight.
If using soldered connections, solder the joint at the P-trap.
Secure the drain Trim
Open the flip drain and insert the grips of a rubber coated pliers into the drain trim and turn to tighten. Be
careful not to scratch the finish.
Install the Overflow Hood
Secure the backplate to the tub by tightening the bolt to one quarter turn past hand-tight.
Thread the overflow hood into the bolt.
COmPLeTe THe INSTALLATION
Complete the Bath Installation
Check all drain connections for leaks and repair as needed.
Install the bath faucet according to the bath faucet manufacturer’s installation guide.
Refer to the bath manufacturer’s installation guide to complete the finished deck or wall around the bath.
