Prior to installation, unpack the mirror and inspect it for damage. If product is damaged, contact Kallista's Customer
Service (below) immediately.
1048645-2-B
Page 1 of 2
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALLATION INSTRUCTIONS
P74204
1048645-2-B
Page 2 of 2
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALLATION INSTRUCTIONS
Description
Model
P74204
Laura Kirar Vir Stil
™
Mirror
Laura Kirar Vir Stil
™
Mirror
INSTALL THE MIRROR
BEFORE YOU BEGIN
THANK YOU FOR CHOOSING KALLISTA
TOOLS AND MATERIALS
We appreciate your commitment to Kallista quality accessories. Please take a moment to review this manual before
you install your Kallista accessory. If you encounter any installation or performance problems, please don't hesitate
to contact us at the phone number listed at the bottom of the page.
Screwdriver(s)
Level
Pencil
Measuring
Tape
Drill
Safety
Glasses
Mounting
Anchors
Multi-purpose
Screws
Position mirror at desired height from floor. Using a pencil, scribe a
line along the top of mirror. This will become Reference Line "A"
(Figure A).
Remove mirror. Scribe a second line (Reference Line "B") 3 1/4"
below Line "A" (Figure B). Use a leveling tool to insure that the line is
horizontal.
While holding the cleat with the larger side facing AWAY from wall,
align the left hole in the cleat with Line "B". Once left hole is secure
(Step 4), you may proceed to the additional holes.
Securing the cleat to the wall may be accomplished by two methods:
● Installer may utilize the pre-drilled holes in the cleat. If the holes
align with the wall studs, the cleat may be secured using
multi-purpose screws (not included). It will be necessary to use
mounting anchors (not included) if the pre-drilled holes do not
align with the wall studs (Figure C).
● If the locations of the wall studs are predetermined, the installer
may drill pilot holes in the cleat to align with those wall studs. The
cleat may then be secured to the wall studs using multi-purpose
screws (Figure D).
Lower the mirror onto the cleat. Ensure that the mirror is totally
engaged before releasing your grip.
THIS DIRECTION
TOWARD WALL
3 1/4"
Reference Line "A"
Reference Line "B"
Mounting
Cleat
Figure B
Mounting
Cleat
Mounting
Cleat
Figure C
Figure D
Multi-purpose
Screws
Desired height
from floor
Reference Line "A"
Figure A
