EN-26
Supplementary guide | Pedelec Bosch Integrale 0.5
Quick-release skewer is too easy to
close.
1.
Open the quick-release skewer.
2.
Hook the quick-release skewer into the
slot and turn it clockwise. This will screw
the axle in the thread. Make sure that
your wheel is correctly centred.
3.
Close the quick-release skewer.
4.
Repeat if necessary.
Quick-release skewer is not easy to
close.
1.
Open the quick-release skewer.
2.
Hook the quick-release skewer into the
slot and turn it anticlockwise until the
quick-release axle protrudes from the axle
hole about 1 cm.
3.
Close the quick-release skewer.
4.
Repeat if necessary.
WARNING
Reattach any previously disconnected cables (e.g. light cables ), other-
wise you could tear them.
3.13.4 Replacing the front wheel
Removing the front wheel
1. Remove the Pedelec battery.
PLEASE NOTE
Detach all cables from the front wheel (e.g. light cables), otherwise
you could tear them.
2. Insert a 6 mm [0.24 in] Allen key into the threaded axle and turn
anticlockwise until it releases.
3. Remove the threaded axle.
4. Remove the front wheel.
Inserting the front wheel
1. Push the front wheel into the front forks and align with the axle holes.
2. Lift the frame is slightly and screw in the threaded axle.
3. Tighten the threaded axle with 12 - 14 Nm [8.9 ft-lb - 10.3 ft-lb] torque
clockwise using a 6 mm [0.24 in] Allen key.
