DCW BedienA Pedelec_RZ5.qxd
● 10 minutes after the bicycle is brought to a halt, the current supply is automatically
switched off (“Automatic cut off“). When you start riding again, repeat the procedure
described above.
(!)
The torque sensor of the bicycle is automatically reconfigured every time you change
the riding mode. This extends the useful life of the battery.
If the LED does not light up during operation, check whether the battery is charged and
securely mounted.
LED light mode when riding
During the trip, monitor the status of the light emitting diodes (LEDs).
If they blink, this is a precise indication that the battery capacity is very low and that
charging will soon be necessary.
LED status on the control panel
LEDs on
The battery has a charge sufficient for your trip. The
available battery capacity is indicated by the lighting up of
the corresponding LED
Blinking slowly
The battery charge has dropped to a low level. The
remaining battery power is 9% of capacity. Recharging is
recommended.
Blinking rapidly and
goes out after about 3
minutes
The battery is completely dead. A recharge is necessary
immediately.
Other forms of LED status are explained in the chapter “Self diagnosis”
!
The LED can show when an excessively high drain of energy is being consumed on a
constant basis (e.g. when riding uphill) or if the battery has not been used for a long time.
Should this occur, press the on/off switch (“Power”) in order to switch off the current and
then press it again to continue operation.
Selection of assistance level (Mode)
You can change the mode settings after the motor is
switched on.
Every time you press the mode switch, the assistance level is switched up or down
accordingly.
The following three modes are available:
high 1:1.3
medium 1.1
low 1: 0.5
Low assistance (energy-saving mode)
If you select a low assistance level you will have a greater range and if you select a high
assistance level, your range will be smaller.
Assistance
level
“Mode"
