KVAULT ODD Replacement
December 2020
101-0269-00 Rev 2
Page 24 of 24
3.
Replace the top lid casing. Set it over top of the chassis 1-1/2”
toward the back, then slide the casing forwards into place. Check that
the screw holes line up.
4.
With the 2.5mm hex screwdriver, loosely fasten 6 screws on the back
5.
Replace 7 screws on the longer side and 6 screws on the shorter
side.
6.
Tighten all the replaced screws.
7.
Replace the rack ears on each side with the “ears” to the front.
Loosely fasten the center screw first, then tighten all 7.
8.
Install the disc vault back into the rack. Use a Phillips screwdriver to
mount the ears to the rack. A two-person lift technique is required to
safely install a disc vault into a rack.
9.
Replace the front panel by lining up the metal tab at the bottom rear
of the panel with the slot in the front of the chassis. Press firmly and
evenly to snap the panel into place.
10.
Reconnect the power cord, Ethernet, and audio/video cables to the
back of the disc vault.
Insert the Discs
The vault should be reinstalled in the system, powered and booted.
If discs were properly ejected using methods 1–3 described in Eject All Discs,
the system will be ready to accept discs. This is indicated by the two blue
LEDs above and below the disc slot. Insert all discs following steps 1-4
outlined in the section Test the Unit . If the LEDs above and below the disc
slot are amber then the vault is busy calibrating or reading discs. Wait for the
operation to complete before inserting additional discs.
If all discs were not ejected properly and had to be manually removed
(method 4 of the section Eject All Discs), or if a disc was stuck in the
defective drive, the system must perform a carousel recalibration. This can
take up to 40 minutes. During this time, the vault disc slot will show amber.
When the vault is ready to receive discs, insert all removed discs ensuring the
disc labels are facing to the right. Press ‘OK’ after the last disc has been
inserted.
Kaleidescape
Support
Get the Kaleidescape Installation Guide at
www.kaleidescape.com/install
See
www.kaleidescape.com/support
for the latest manuals and guides,
Knowledge Base, and more technical and customer support resources.
For additional information, contact Kaleidescape Support.
Send an email message to
Call the support line at +1 650-625-6160.